Question About Reinforced Concrete 8.61 Scaffolding Solution

B

BURAK AKTÜRK

New Member
You do not have permission to view link Log in or register now.
Iskele.rar.html Hello, although I tried my project in the link many times, it shows errors like insufficient section in the report section in scaffolding solution. I would be very grateful if you could help me where I am going wrong Thank you
 
Hello, I did not examine your file, but I had many errors in a project that was solved in 8.601. I saved the file as a different file and continued in 8.504. I made it save. I reanalyzed the error-free file in 8.601, again there were many errors.
 
I did not review your file, but the problem occurs on the steps or side arms of the scaffolding ladders. It will be correct to solve it in V8.5x. Then you can get the report and drawings in V8.6x.
 
i am having the same problem. Although it selects the sections by itself, when I receive a report, it shows errors in the columns. the only solution is to solve it in 8.5?
 
Hello, I could not download the project file from the link you sent. Could you please send your file via wetransfer or to [email protected] mail address? Which sections are insufficient in the project? There may be default wall loads on the beams. or stair sections may need to be enlarged. You may also need to recheck scaffolding pavement loads. When using the template projects prepared in 8.61 installation, there is no problem in scaffolding projects. In the attached picture, it is seen that the analysis results of a 16-span and 10-floor scaffolding with the sample template project in the 8.61 version are sufficient. Best regards...
 
You must log in or register to reply here.
Back
Top