Program Creates Laying Meshes Incorrectly

E

ebasakin

New Member
Have a nice day; In the project in the attached project, the floor networks do not form properly, especially in the basement of the building. This situation also causes faults in the flooring. I deleted the Basement Floor completely and copied it from the top, but the problem did not go away. How can I follow a solution? I think the upper floors have the same problem.
You do not have permission to view link Log in or register now.
 
I remodeled the project, but this time I encountered a mode number and nd error even though it is a small building and the sections are considered large. As far as I can see, there are no errors in the modeling.
You do not have permission to view link Log in or register now.
 
Hello, You need to correct the stair support conditions in the model. The support conditions on the edges of the stairs I have shown above should be like this. Fixed supports are assigned to these edges in your model. Since you put a fixed support on the edge of the stairs, the K05 beam was getting torsion, shear and mode insufficiency errors. If you correct the support condition, the problems will disappear.
 
In addition, when we look at the deformation of the staircase on the 1st basement floor, we can see that the staircase does not work properly. If a ladder is created with the route lines I have attached, there is no error in the deformations.
 
You must log in or register to reply here.
Back
Top