POOL modeling in idecad Static 6.54

[Görkem2007]

Hello, we need to model a pool in a villa project we made in Idecad Statik 6.54 program. I modeled the pool with the "Pool" tool in the toolbar, as described in the video in the training section of your site and the relevant sections in the user manual. I had a pool analysis done. After that, we can read the moments of the pool in the "3D Frame view" from the program. However, as far as I understand, the reinforced concrete calculation, report and drawings are not yet in the program. Is there a way to generate them with ideCAD Static? Since the program calculates these moments, I think there must be a file somewhere where these values can be read. Is there a way to extract these moment values from a file generated by the program itself? Good work. Görkem Demircioğlu Civil Engineer Nicosia - TRNC

 

[HakanŞahin]

Hello, Pool reinforcement results can only be obtained by examining them from a 3D perspective... After the pool is defined and the pool is calculated, pool results are selected from the 3D perspective, view results dialog. You can select any upload status from the list by clicking the upload icon in the lower right corner in perspective. When As 1 and As 2 are marked, clicking on the "Existing reinforcement area" line activates the line where reinforcement diameter and spacing can be defined. By entering the reinforcement and spacing values on this line, simultaneous color change is observed in the graphic. The regions that are sufficient due to the amount of reinforcement entered are painted in the color of zero value. (The values of the color palette are followed at the bottom of the graphic image) This process is done both for the upper zone by clicking the "upper reinforcement areas" option, and for the lower zone by deselecting the same option. In this way, the required reinforcement for the pool is determined in the program for both tension and compression zones. After this stage, pool reinforcement drawing is made using the drawing facilities. Good work...