Point capture problem in the imported architectural project

B

baahri63

New Member
hello, I was going to start a new project. I imported the architectural project. Although the program captures the architectural project point that I imported to draw the axis, it moves the axis not to the region where the axis is located, but slightly beyond it, that is, it shifts the axis. I sent a photo from the address
You do not have permission to view link Log in or register now.
. I would appreciate if you could help
 
Re: POINT CAPTURE PROBLEM IN IMPORTED ARCHITECTURAL PROJECT One of the deadlocks is open. For example, if lock-to-grid is turned on (even if the grid is not visible), the grid will capture intersections.
 
Re: POINT CAPTURE PROBLEM IN THE IMPORTED ARCHITECTURAL PROJECT I checked the deadlocks before, but it gives the same problem again. When you zoom in, you notice that the axis is shifted. I have sent the file to
You do not have permission to view link Log in or register now.
, I would appreciate it if you review it. Good work..
 
"baahri63":vj5wckoh" said:
good luck. I was going to start a new project. I imported the architectural project. Although the program captures the architectural project point I imported to draw the axles, the axis does not move to the region where the axis is located, but just beyond the axis, that is, it shifts the axis.
You do not have permission to view link Log in or register now.
. I would appreciate your help
Click to expand...
Hello, The imported drawing is far from the origin point. In the coordinate. Move the drawing to the origin point. Also, it is seen that there are small differences between the distances and dimensions between the imported objects. For example, the distance between 2-3 axes is measured as 421 cm. However, when the distance is measured, this value is 420.66 cm. Good work
 
Thanks for the information you gave Mr. Levent, I solved the point capture problem, but as you mentioned for example, when dimensioning between 2-3 axis autocad file, it is 421 cm
You do not have permission to view link Log in or register now.
. When idecad is statically imported, it measures 420.66. What do you think is causing the problem?
 
"baahri63":3ayavtg7" said:
levent, thanks for the information you gave, I solved the point capture problem, but as you mentioned for example, when you measure 2-3 axis in the autocad file, it is 421 cm
You do not have permission to view link Log in or register now.
. When idecad is statically imported, it measures 420.66. What do you think is the cause of the problem?
Click to expand...
Hello again, a measurement that should be 421 cm. Measuring 420.66 cm, it indicates that the measurements are rounded in 2D drawings.
 
You must log in or register to reply here.
Back
Top