Picture about ideCAD Ladder is attached

G

gencideci

New Member
As you can see in the attached photo, when you create a new staircase, it comes out at a low level. A friend said that there was a solution to this, but I couldn't find the opportunity to show it, and now we are not on good terms, I can't ask. Please help urgently. I have a project to complete tomorrow... image:
You do not have permission to view link Log in or register now.
 
Re: Urgent information about İdecad Ladder. picture attached Hello, After creating the first area in the staircase, you need to use the add stair area command for the continuing areas. It seems that after creating the first area in the image you sent, you used the create ladder command again for the area you want to add. Good work.
 
Re: The picture about İdecad Ladder is attached You did not enter the data. but you created the visible stair exit directions incorrectly. when you create the outer contours of the stairs, specify the exit direction respectively according to your exit direction.
 
Re: Picture about İdecad Stairs is attached
"saridurmus":ye27t84w" said:
You did not enter the data. But you created the visible stair exit directions incorrectly. When you create the outer contours of the stair, specify the exit direction in order according to your exit direction. When the route command draws each exit direction, leave the command and draw it again. Thank you. As you said, the route command is related to the direction.
Click to expand...
 
You must log in or register to reply here.
Back
Top