Panels not visible in column application

B

babisko_fet

New Member
Dear friends, In our previous versions, panels were also determined in the column application plan drawing. In this version, neither the panels of the basement floor nor the panels on the floors are visible in the column application plan in this version. If there is a programmatic defect, I would like it to be corrected, and if there is a lack of command, please let me know what the regulating command is A.Semih ELDEK İnş.Eng.
 
Re: PANELS NOT VISIBLE IN COLUMN APPLICATION When you click on the column application plan drawing, if you click on the show details tab in the tab that appears, the curtain details will be displayed with the columns in the plan.
 
In version 7.20, it is not possible to place the panels in the column application. I don't remember for 7.19, but in 7.xx versions, the panels were visible in the column application with the OPEN DETAILS IN PLACE command. I couldn't find how to show it in this version. I don't know where I missed or what I didn't do... Moreover, I've been using this program since 1988. So I'm even angry with myself.. What should I do, what should I add or is there really this error in 7.20 Semih ELDEK İnş Müh
 
"babisko_fet":19m540xh" said:
In version 7.20, it is not possible to place panels in the column application.. I don't remember for 7.19 before, but in 7.xx versions, the panels were visible in the column application with the OPEN DETAILS IN PLACE command. In this version, I could not find how to show it. I don't know what I haven't done... Moreover, I've been using this program since 1988.. So I'm even angry with myself.. What should I do, what should I add or is there really this error in 7.20 Semih ELDEK İnş Eng
Click to expand...
Semih Bey, hello, I have a problem like you mentioned. We don't know the problem. Could you add your project to the message and write the step-by-step process?
 
Mr. Hakan Mrb, Operations done 1-floor and elevation status of the building was entered 2-Concrete and steel strengths were determined 3-axles were formed 4-columns and curtains were placed 5-floors were determined 6-Stairs were determined 7- calculations were made 8-foundation application was taken 9 -basic beam expansions taken 10 COLUMN APPLICATION &lt;<DETAYLARI YERİNDE AÇ> &gt; TAKEN BY COMMAND ........ curtains are not in the DRAWING 11-Curtain details have been drawn Basement curtains and floor curtains have been copied from 12-curtain details and added to COLUMN APPLICATIONS. The project is attached. Solutions were made in both 32 bit and 64 bit Results Best wishes Semih ELDEK
 
Thank you for your help... Sometimes we can&#39;t see what&#39;s in front of our eyes and we keep making the same mistakes. Thank you again
 
You must log in or register to reply here.
Back
Top