Number of rigid basements x and y separately

[Medeniyetmuhendisi]

In the report, the number of rigid basement floors and floor numbers for the X and Y planes are separate. Normally, both of them are in the same municipality, there was a problem at the approval stage, if you could help me, I would appreciate it. I added the project as well.

 

[YasinTezel]

Hello, There has been a problem with the definition of rigid floor in your project. Perform the following steps to resolve. Enter floor general settings, define ground floor as rigid floor in X and Y directions and analyze. Re-enter the floor general settings, remove the rigid floor option in X and Y directions for the ground floor and analyze again. When you get a report, the problem is fixed.

 

[Medeniyetmuhendisi]

Hi, There is a problem with the definition of rigid floor in your project. Take the following steps to solve it. Enter the floor general settings, define the ground floor as a rigid floor in the X and Y directions and perform analysis. Enter the floor general settings again For the ground floor, remove the rigid floor option in the X and Y directions and analyze again.The problem is fixed when you receive the report.

Thank you, I did the same as you said while I was trial and error, and the report was fixed.

 

[YasinTezel]

We found that the situation occurs when the rigid solid in the X and Y directions is defined at different floors and then these floors are deleted. Precautions will be taken in the next version to avoid this situation.

 

[Medeniyetmuhendisi]

We found that the situation occurs when the rigid solid in the X and Y directions is defined at different floors and then these floors are deleted. Precautions will be taken in the next version to prevent this situation.

I think so, thank you for your attention.