node values

[gunner]

have a nice day. What is the unit of the displacement values we look at from the 3d frame after the analysis in the attached project? Is it mm or cm? I couldn't find either.

You do not have permission to view link Log in or register now.

is the one above the beams I framed in red right, do you think? Frankly, it didn't sit well with me. For now, I haven't touched it because I've seen it done this way in many places and it doesn't cause any problems in analysis. In the lower beam that I took to the frame, the span is 8 meters and a beam is stuck. The maximum displacement in the vertical direction is in these two beams. Before I finish the modeling completely, I wanted to get an opinion of you, my dear friends, throughout the project. Thank you in advance.

 

[Levent Özpak]

good day. After the analysis in the attached project, what is the unit of the displacement values we look at from the 3d frame? Is it mm or cm? Click on Settings line.In the dialog that opens, you can see the unit in the 3d frame from the Deformation line.Good work

 

[gunner]

Thank you for your reply, Mr.