Making an inclined column

[mustafa.19]

In the attached hotel project, the column S32 (at U-1 AXLE INTERCEPTION) is located on the ground floor. After the basement floor, the 3 columns in this line on the ground floor-mezzanine floor-1.normal floors and the columns located at the U-6 AXLE INTERCEPTION on the right side of them get smaller by 24 cm. I want to give this shrinkage from the ground floor to the 1st normal floor inclined. What should I do for it? When I enter the 24 cm bending value to the slope in the column properties, there is bending in the other direction, contrary to the direction I want. Thanks in advance.

 

[YasinTezel]

In the attached hotel project, S32 (U-1 AXLE INTERCEPTION) column is located on the ground floor. After the basement floor, the 3 columns at this level on the ground floor-mezzanine-1.normal floors and their right Columns located at the U-6 AXLE INTERCEPTION on the U-6 AXLE INTERSECTION on the side of the column are shrinking by 24 cm. I want to give this reduction from the ground floor to the 1st normal floor as inclined. What should I do for this? Thanks in advance.

You can't define a column with variable cross-section, there is no such possibility. If you want to bend the column without changing the cross section. Delete the columns you will bend, First of all, go to Column settings and enter the curvature value (24cm) , The column will be bent in the width direction, Your column For Width 162cm and Height 30cm, enter the dimensions.After making the settings, you can adjust the tilt direction with the mouse while drawing the column on the plan.