Ladder size

[sC.oUT]

Hello friends. I can get the number of reinforcements in the staircase drawing, but I cannot get concrete, iron and mold quantities in the quantity section.. Did I make a mistake while defining the staircase? If I made a mistake while defining it, how did it give the reinforcement drawing? I will be glad if you help..

 

[Levent Özpak]

hi friends. I can get the reinforcement numbers in the staircase drawing, but I can't get the concrete, iron and mold quantities in the quantity section..I wonder if I made a mistake while defining the staircase? I would be glad ..

Hello, Formwork and concrete quantity for stairs are not prepared automatically. However, the reinforcement quantity can be accessed from the quantity report and the stair drawings reinforcement table. If you add your project, we can examine the problem of not obtaining the reinforcement quantity.

 

[sC.oUT]

Thank you Mr. Levent. I'm about to settle. If I ask you a question other than the ladder: I am trying to incline the panel in the attached project, but ? p01 and p07. The upper level is 305 cm as understood from the project. the bottom will be at 0 elevation.

 

[Levent Özpak]

thank you, Mr. Levent. I'm about to settle it. If I ask you a question other than the stairs: I'm trying to tilt the panel in the attached project, but ? It will be at level 0.

There is no possibility to draw curved panels in the program.