Kiris Cizimde Hata...

A

aozhan90

New Member
Hello, the first picture is the beams on part of the reinforced concrete roof. The beams between K7 and K10 appear as in the 2nd picture in the drawing. What could be the cause of this error? Good work..
 
Re: ERROR IN THE BEAM DRAWING..
"aozhan90":7q1qsxxv" said:
Hi, the first picture is the beams on a part of the reinforced concrete roof. The beams between K7 and K10 are shown in the drawing as in the 2nd picture. Why is this error caused? Good work..
Click to expand...
Could you add your project?
 
Re: ERROR IN THE BEAM DRAWING.. Two different names are given to the inclined beam divided by the floor edge between the columns S14-S15. The slopes and directions of these beam segments are not compatible. It would be appropriate to define the beam as in the example. Note: In the dividing beam between S14-S10, the elevation is not compatible with the columns. In addition, there is the situation between S14-S15 between the divided parts of the beam. Good work
 
Re: ERROR IN THE BEAM DRAWING.. When you make the roof inclined according to the architecture, statically absurd beams and floors are formed. But I applied as you said, problem solved. Thank you. Good work.
 
You must log in or register to reply here.
Back
Top