It creates a floor area at the junction of the column.

M

muhendis16

New Member
First of all, hello, in the attached project, as observed while performing the slab analysis of D03, S04 creates a slab area at the junction of the column. Does anyone know the reason why I couldn't get over it even though I paid attention to the knot points with my love and respect.
 
Re: There is a problem that I can't solve in one of the slabs Hello, you can connect the beam K19 to the column S04 so that it coincides with the lower left corner of the P04. Note: In the project, the beams numbered K04-07-17 have been given positive elevation. Columns and panels to which these beams are attached should also be given an upper level. (Vertical continuity should be ensured by giving elevation to the relevant columns and panels on an upper floor.) Good work.
 
Re: There is a problem that I can't solve on one of the flooring Thank you Mr. Levent for your interest. I confirmed it again and again. I am also aware of the situation regarding your note, thank you for your advice and I wish you a good work.
 
You must log in or register to reply here.
Back
Top