It continuously accepts the K5 beam after the K3 beam.

[merthamide]

My K4 beam in the image is not visible in the drawings. The program continuously accepts the K5 beam after the K3 beam. We were solving the problem by changing the angle from somewhere, but now I can't remember.

 

[Levent Özpak]

My K4 beam in the image is not visible in the drawings. The program always accepts the K5 beam after the K3 beam. We used to fix the problem by changing the angle from somewhere, but now I can't remember.

Hello, in the General Reinforced Concrete Parameters dialog "The angle between This is done by entering a value in the line "Continuously accept beams/curtains with small difference".