Is there no "S" Stretch command in ideCAD 8?

[Apocalpyse]

"S" enter so stretch command is not in ide8 I wonder if I couldn't find it thanks

 

[HakanŞahin]

Hello. The command you mentioned works with the abbreviation Sn instead of S in version 8. Use Sn instead of S. or, If you wish, you can change this abbreviation in the "idecadalias.txt" file in the program folder. As seen in the attached picture, you can use s instead of Sn with the abbreviation s.

 

[Apocalpyse]

thank you sir

 

[bartayd]

it says access is denied, which folder is it in when we change it from customize. Whatever it is about "sn", we make a single letter two letters while making a hotkey.

 

[HakanŞahin]

it says access is denied, which folder it is in when we change it from customize. Make the change there.Then copy the file into place.You can give the relevant irrelevant letter you want

 

[bartayd]

Thank you