IS IT A VERSION DIFFERENCE?

Y

yakubu

New Member
I OPENED THE PROJECT MADE IN IDECAD 5 IN VERSION 6, BUT I CAN'T SOLVE IT, WHAT GOES WORTH? CAN YOU HELP ME.?
 
Mr. levent, the system is being resolved. However, column reinforcements and Nd loads are abnormal. even the top floor columns do not recover according to the axial load.
 
In your project, calculations were made according to the Heat Loads in the Analysis Settings. The coefficient of thermal expansion is 1 in the material properties defined in the Structure Tree. (Because you are reading from the old version) Enter this value 1E-005 In addition, both T1 and T2 temperature differences are entered as 30 degrees.
 
You must log in or register to reply here.
Back
Top