Insufficient stapling strength

G

gunay.17

New Member
I am a 4th year Civil Engineering student. I am drawing a project to learn İdecad. I am drawing and comparing a project whose static project has been drawn. I received a warning that the punching strength is insufficient, basically, I increased the thickness, it still did not meet up to 300 cm. In the drawn static project, the thickness was 70 cm. I think there is an error in the drawing. I would be glad if you help. Thanks. Project
You do not have permission to view link Log in or register now.
 
Hello My suggestions; --Make the load-bearing system behavior coefficient 7 in both directions, --Set the stiffness ticks of the BASIC floor from the floor general settings, --Remove the outer floors of the curtains in the BASIC floor, (therefore it gives a punching error.) --The ladder is not supported, --2. You can reduce the live loads on the KAT floors. Unver ÖZCAN
 
"unver":2bgahkp1" said:
Hi My Suggestions; --Make the structural system behavior coefficient 7 in both directions, --Set the stiffness ticks of the BASIC floor from the floor general settings, --Remove the outer tiles of the curtains in the BASIC floor, (hence the punching error -The ladder is not supported, -You can reduce the live loads on the floors of the 2nd FLOOR Ünver ÖZCAN
Click to expand...
Thank you
 
You must log in or register to reply here.
Back
Top