INCORRECT AND MISSING DRAWINGS

[kasky]

KZ152 KZ118 KZ146 KZ 140 KB116 KB115 What are the causes of faulty drawings in the beams, thank you in advance, and I do not want the support to be used in the beams, will it be a mistake if I remove the extra click from the equipment selection

You do not have permission to view link Log in or register now.

 

[Levent Özpak]

In the beams you mentioned, the program did not break the pillar because the pile breaking conditions did not occur. However, you wanted to create a pile manually. Removing the pleats solves the problem.

 

[kasky]

There is no jig in the kb116 cross and can we get a solution without using a support?

 

[Levent Özpak]

kb116 corner has no drawbars and can we get a solution without using a support

I can see the reinforcements on the K16 beam in the basement and in the drawing.

 

[kasky]

I don't see it, but it looks normal in reinforced concrete beam reinforcements. There is a problem with the drawing

You do not have permission to view link Log in or register now.

 

[Levent Özpak]

In case the right support of KB116 is not visible in the attached project, BAP20 panel is connected to the S24 column from the lower node. If you still can't see the equipment, call tomorrow.

You do not have permission to view link Log in or register now.