HELLO, IN A PROJECT I DRAWED, THERE IS AN ERRORS ONLY IN THE REPORT SECTION AND I MADE MANY CHANGES ABOUT THE COMPOSITION BUT I CANNOT GET ANY CHANGE AT THE RESULT OF THE ACCOUNT, WHY I CANNOT MAKE AN ACCOUNT RESULT
Re: HELP Hello; If you use a stiffener in the junction of the butt plate beam joint, the design is not done, so the strength insufficiency ratio seems to be an impossible value. If you want to get a report, turn off the stiffeners. Good work.
German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish