German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish I shared the staircase design I wanted to make in the attached photos. I want to define the landing as a step in the spiral staircase, at first I define the landing as 2 steps and reduce the number of steps to 1 from the areas section, but although it improves in 2 dimensions, it is as in the photo in 3 dimensions. I will be glad if you can help, good work
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
How do I define the Stair Landing as a rung?
- Thread starter 201968
- Start date
Levent Özpak
New Member
Re: STAIR STAGE STAGE SAHANLIK
Hello, if you add the IdeCAD project file with the two-dimensional drawing of the ladder, we will help you. Good work."201968":2xhpvvtw" said:Can you help with the design of the ladder
Levent Özpak
New Member
Re: STADER STAGE STEAM SAHANLIK
Hello again, You can create the stair routes as in the example, and select Area3 in the Stair Settings/Areas tab. You can create it by unchecking the line "The last step is at upper level."201968":2v8ctkmq" said:Levent Bey, the project is attached...
Levent Özpak
New Member
Re: STAIR STEP STEP SAHANLIK
When you change the number of steps to 4, the step height will be the same as the other branches. Good work"201968":2he6paor" said:Levent Bey, in the example you gave, the step height is lower in FIELD3 compared to other areas, isn't it wrong?