How do I define my beam right and left end at different elevation

T

teknoadam

New Member
I want the right and left ends to be at different levels by giving the lower and upper levels of my beam, but only the right level can be given in idecad, how can I do this?
 
If you do not give a value to the jeans part, it will be at floor level. If you value the elevation value - (minus) then + (plus) value below the floor, you will set it above the floor. In this way, you bring both parties to a certain quota. After that, you will have leveled both ends with the value you will only give to the right end. N. YILMAZ
 
Mr. Yılmaz, in this model of mine, there are no non-inclined beams, since they all have a moon shape at different elevations, and the upper levels of the columns are different so that they have a moon shape when viewed from above and from the outside. I designed this model, there is no problem in my geometric control, but I couldn't assign a tile. It doesn't fit. Can you help me on how to do it if I send you the model?
 
You must log in or register to reply here.
Back
Top