How can I transfer soil load for pit analysis

[bektasmehmetali]

hello, I wanted to make a pit analysis to be used as a manure pit, but how can I transfer the soil load to the pit (I know the unit volume weight of the soil and other values) or I want to take the curtain to the minus (-) level of the ground in the program, but the program says an elevation error and does not accept it. how can I do that. Do you have an extra solution suggestion for this kind of pit? Thank you in advance for your interest. NOTE: I am just starting to use static programs. I have sufficient technical knowledge and do you have a video or document resource that you would recommend for understanding the program or for static calculation (training videos published for idecad show the basic concepts. source )

 

[unver]

Re: cesspit Hello My suggestions:

hello, I wanted to make a pit analysis to be used as a manure pit, but how can I transfer the soil load to the pit (I know the unit volume weight of the ground and other values)

Check out the links below:

You do not have permission to view link Log in or register now.

You do not have permission to view link Log in or register now.

NOTE: I'm just starting to use static programs. I have enough technical knowledge and do you have any video or document resources you would recommend for understanding the program or for static calculation (idecad The training videos published for the program show the basic concepts. What I want is a resource that specifically addresses the causes and solutions of the report errors that are frequently seen in the program )

Examine the answers given to the questions asked in the form. Unver ÖZCAN