High relative floor drift problem in cassette flooring

A

aezgicakici

New Member
I tried to solve the 3-storey building with floor class Ze in cassette flooring without curtains, but when it comes to cassette flooring, I think we need to add curtains, I added curtains and it gave more errors at that time. First of all, ide10 throws too many curtains in hollow floor projects, or does the same problem occur in cassette flooring, in general, is it not too many curtains for a 3-storey building? I threw a horizontal and a vertical curtain, what should I buy r, and when I get 7, it gives an error saying "4/5 R should be taken instead of y direction carrier system behavior coefficient R". and there are many more errors
You do not have permission to view link Log in or register now.
=> this is the project I drew
 
Hello there; First of all, your project needs some adjustments, I'm listing them below. You can re-evaluate after editing. 1- Analysis Settings / TBDY2018 Analysis settings wizard, coordinates of your structure, carrier system type, etc. make the arrangements. The project coordinates seem to be the ide structure Istanbul office. 2- If you are going to make a building-based interactive solution, make sure that the Bed coefficient and Bearing capacity information are entered correctly. 3- If you are going to lay a filled cassette, your tooth spacing should be at most 70/70. Edit it this way. 4- Define a beam between the columns S02-S03 and S10-S11, which are marked in both the hollow block or the cassette. 5- You can lighten your building by choosing the plate thickness of 7 cm for both hollow blocks or cassettes. 6- Enter the stair landing as a 15cm slab floor, it is more suitable for stair support. 7- Enter the weight of the flooring request filling material into the system as it should be. 8- Pay attention to the errors in the geometry control. Best regards.
 
You must log in or register to reply here.
Back
Top