Help with curtain fittings

M

mcoban

New Member
When I took the reinforcement expansions of the curtains in my project (especially in the oval curtains in the basement floors), I observed that the openings were not formed properly, because of my geometry errors or because I could not model the curtains properly. Also, when I make polygon columns in the ellipse section of the project, the reinforcements do not appear in the application plans. I would appreciate if you examine and help. respects.
You do not have permission to view link Log in or register now.
 
Greetings, In your project, go to the Reinforced Concrete section of the Design Parameters and type a maximum of 29 degrees on the "Continuously accept curtains and beams" button in the general reinforced concrete parameters, and then take the printout and correct it by using the two-dimensional possibilities. Good work.
 
You must log in or register to reply here.
Back
Top