HELP....Tile identification Problem

H

hemsho

New Member
Hello, I am civil engineer. I am a senior student and I am completing my graduation in the idecad 6.0 Demo program.. I could not draw a tile that is in the mold plan of my project. I entered the create tile command, I created the closed area that will be a tile, but the program does not see it as a tile... I want help on this issue
2120.jpg
 
Hello, The reason why the slab does not form may be due to the fact that the edge of the slab is not attached to the beams. If you add the project, it will be easier to understand where the problem comes from. good work
 
hello... first of all, thank you for your reply.. I did what you said, I failed again, I put my idecad work. As for the flooring dimensions, it will be 260 cm high and 120 cm wide.
 
I am attaching your project with the tile placed. However, since you did not put the project as it is in the picture, I cannot say where the mistake was made. Good work
 
Hello again, Mr. Levent, I did my project again, you did it wrong in some places (not introducing the curtain as a panel), I had corrections, but I had a re-tiling problem, would you help me if I send you the file again? By the way, my building will be symmetrical, even though my balcony floors will be symmetrical, I drew the symmetry axis in the project...
e0c1ad5d440f9aad43365f48e4267ed6.jpg
 
There was an error while uploading my project, I uploaded it again .... I fixed it, I wish you a good day....
 
There is one slab edge under dimensioning between the K140-K89 joists. That slab edge is not bonded (divided) to the K89 and K140 joists. Delete it or, if it will be, re-enter it with the "divide by intersection" command active. The slab edges that define the balcony edges between the CB axis are not drawn to be continuous from each other. I am attaching an example in the message where both situations are fixed. Good luck with...
 
Hakan, thank you for your interest... I downloaded the corrected file, but I couldn't open it in the program.. I'm using the demo version because I'm a student.
 
I edited the project I added to the message in the demo version. I guess our versions are different. The demo version I have is our latest version and the number is 6.0101. It's good to use it. If you click on the Help/ ideCAD About Static line, you can see the demo version number.
 
First of all, it's been a little late due to the internet problem and the intensity of my classes, thank you for your interest, Hakan.
 
You must log in or register to reply here.
Back
Top