German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish omeragar04
New Member
Good work. I want to gusse the places in the picture, I don't know how to add them in Idecad. I would be glad if you help. Best regards...
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Guse
- Thread starter omeragar04
- Start date
Levent Özpak
New Member
Hello There is no possibility to define guse for columns in the program. If the need for Guse identification is required due to the short console formation, you can review Ts 500- item 8.4 and make the necessary verification and drawing arrangements. Good work
omeragar04
New Member
Thank you Mr. Levent for your reply. I had one more question, would I get the same result if I placed the column header in the specified place?
Levent Özpak
New Member
Column cap, the structure used to increase the punching strength in beamless tiled systems (TS 500 article 11.4.4, figure 11.3-11-4)"omeragar04":3lef63eo" said:Thank you, Mr. Levent, for your reply. I had one more question, would I get the same result if I placed the column cap at the specified place?