Ground Floor Column stirrup compaction

[hydrkrmn]

In the project I have drawn, our ground floor height is 4.50 meters, since the foundation is below the frost depth and there is a sub-basement curtain, and we were asked to tighten the ground floor column stirrup. I wonder if I can handle this in the idecad interface or do I need to fix it on the sheet. Thank you for your attention, take it easy.

 

[actombo]

Reinforced concrete ---->column---->transverse reinforcement tab, you can make stirrup tightening at any interval you want.

 

[YasinTezel]

Hello, Stirrup tightening is done automatically. Since there is a sub-basement wall, the column compaction zone starts from the top of the curtain. If you want to change the spacing of the stirrups or if you want to tighten completely, the transverse reinforcement intervals can be changed in the reinforced concrete column dialog. In addition, the length of the lower end compaction zone of the column can be changed in the "Static/Reinforced Concrete" tab in the column properties.