Ground bearing capacity error.

MrtGrsl

New Member
The bearing capacity error appears, but the base beam pressure is below the limit value, what is the reason for this error?
 
"MrtGrsl":1rihnalj" said:
The bearing capacity error appears, but the foundation beam is below the ground pressure limit value, what is the reason for this error?
Could you attach the project file?
 
Hello, I did not look at your project, but the lack of bearing capacity may have been caused by negative ground tension.
 
In the project you added, negative stress occurs in TK01 and TK15 foundations. Since the "Check for negative stress in foundations" option is checked in the "Analysis Settings/Foundation-Foundation" tab, it gives a warning "Errors have been detected in the project."
 
Back
Top