German 
French 
Spanish 
Portuguese 
Italian 
Arabic 
Russian 
Japanese 
Turkish Hello everyone, good work, I have some questions, I would be very happy if you could help. 1-) I could not solve the gradual basic part of the project, I think I am making a mistake in data entry. I also added the architectural project, I showed the part to be built gradually, next to the basement floor plan, there is also a section. 2-) When I add the basement curtains on the 3-e' axis, B2 irregularity appears. How can I fix it? 3-) I entered the engine room on the top floor as a separate floor, can we get the same result when we give the upper level and solve it?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Gradual Basic
- Thread starter bymhndis
- Start date
Hello Suggestions.
--Basically, the solution by editing I did it, it doesn't give an error, in the attachment,"bymhndis":1wl92860" said:1-)I couldn't solve the gradual foundation part of the project, I think I made a mistake in data entry. I added the architectural project as well, I showed the part to be done gradually, next to the basement floor plan, and the cross section is also available.
--Importance of B2 irregularity because semi-rigid diaphragm is resolved no, it says in the report,"bymhndis":1wl92860" said:2-)When I add the basement curtains on the 3-e' axis, B2 irregularity appears. How can I fix it.
--It is more appropriate to give it as a floor, Ünver ÖZCAN"bymhndis":1wl92860" said:3-)I entered the engine room on the top floor as a separate floor, can we get the same result when we give the upper level and solve it
Hello, thank you for your answers, Mr. Unver, 1-) I need to create a slab between two foundations as in the attached picture, when I do this, infinite values come out, so it gives a relative floor drift error. I don't think I can make such a definition. 2-) What can I do if I want to fix the b-2 irregularity, other than deleting the curtains, thank you again for your interest.
Levent Özpak
New Member
Hello, You can define the stepped foundation as in the attached project"bymhndis":3ft6n4d0" said:Hi everyone, good work, I have some questions, I would be very grateful if you could help me. 1-) I couldn't solve the gradual foundation part of the project, I think I made a mistake in the data entry. I added the architectural project, I showed the section to be done gradually next to the basement floor plan Available.
A1 and B2 type Irregularities for the selection of calculation method. This irregularity is of no importance as dynamic analysis is performed."bymhndis":3ft6n4d0" said:2-)When I add the basement curtains on the 3-e' axis, B2 irregularity appears, how can I fix it.
raft foundations cannot be connected to each other by flooring.One is the foundation element and the other is the floor element.Good work"bymhndis":3ft6n4d0" said:1-) I need to create a slab between two foundations as in the attached picture, when I do this, infinite values are obtained, inf, it gives a relative floor drift error. I think I cannot make such a definition.