geometry errors

[mkrts88]

-Unsupported beam -Cannot create mesh for flooring. There are errors, and raft foundation does not save with Ø16 irons. Problems go away with Ø22 and above irons. Can't it be done with Ø16 irons? I'm talking about the upper and lower mesh in the raft, it was a project that was revised in a similar situation. There was no problem in the previous similar case. Guys, I apologize in advance for taking up your precious time. I tried a lot before sharing it with you. Waiting for your experiences Thanks in advance

 

[Levent Özpak]

Hello, In the project, model the curtains (especially the basement perimeter curtains) as shells. -Tile meshing problems will be solved. -Enter the properties of the K04 beam and exit by saying "OK". Unsupported beam error in geometry control will be fixed. -Rat slab saves the main reinforcements with its 16mm reinforcement diameter. Good work

 

[mkrts88]

Thank you, Mr. Levent. Have we reduced the stiffness by modeling it as a shell? How did we create the flooring, what was the problem and we solved it? Can you explain a little bit?

 

[Levent Özpak]

Mr. Levent, Thank you. Have we reduced the stiffness by modeling it as a shell? How did we get the slab to form and what was the problem? Can you explain a little bit?

P06 and P11 24 meters and 28 meters long curtains. Slabs These walls, which were modeled as bars, could not be connected correctly and floor nets were not formed.When modeled as shell, this problem was solved.Also, the loads were transferred to the raft foundation more homogeneously by modeling the panels as shells.Good work