Geometry Check And Modal Error

C

civilman

New Member
The project gives a modal error during analysis and asks for geometry control, but says there is no error in geometry, the objects are suitable. I even got a report without any problems before, but now it gives an error. Respects.
 
In your project, the problematic node and its coordinates are given in the analysis status window. Looking at these coordinates, there is a piece of beam at the junction of the K113-K114-K34 beams with their names on the 1st floor. If this beam segment is deleted, the analysis is complete. Also in the project; * Floor edge is entered under the K20-K35 beams in 5-floor. *From the properties of K113-K114-K4-K25 beams on which D125-D126-D127-D4-D19 console floors sit, -This beam bears the console floor- option should be selected. Good work
 
You must log in or register to reply here.
Back
Top