Entering wall load with wall icon

[leyla12]

Hello. I make the wall effect by modeling the wall load on the beam with the wall icon. First of all, I get the beam wall load of 0 in statics and with the wall icon, I model the wall for this beam and open a door or window to make it. My question is as follows, when I model the wall on the beam with the wall modeling icon in this way, does this wall load automatically affect the beam, so will the dead load on the beam come from the wall I modeled in the calculations?

 

[Levent Özpak]

The walls act on the structure as a load in the analysis model. You can view load values numerically in beam reports or as images in a 3D visualization.

You do not have permission to view link Log in or register now.

 

[mustafaureyen]

Its only disadvantage is that it takes the load in the calculations on the walls coming to the flooring, but it does not appear in the calculation report. For this, it is necessary to enter a linear load on the floor. The building inspection says that the loads on the slab are not taken, or it is necessary to take a screenshot from the 3D visualization and put it in the reports.