Entering İdecad Soil Investigation report into the system

C

Civilengineer48

New Member
Good day everyone, I want to ask a short question. Ground survey report coming. Here I enter the bed coefficient, soil bearing capacity and unit weight according to the soil survey report in the Foundation-Soil tab in the analysis settings section. Then I enter the analysis wizard and enter the ground class. My question starts here. I come to the design spectrum tab and enter the coordinates in the ground survey report. Here the program gives its own automatic values in offline mode. (Ss,S1,Sds,Sd1,PGA,PGV) Some of these values can be changed, some cannot. There are slight differences between the values in the ground survey report and these values. What am I supposed to do here? Do I need to change these values? Or is it enough if I use the values that come in offline mode?
 
Hi, the spectrum values obtained by using the Offline option in the TBDY wizard are calculated by the program. Since Afad and ideYAPI use different algorithms, the values do not exactly match.
 
You must log in or register to reply here.
Back
Top