Elevator Upper Part Problem

[Reform Group]

Hello friends, I am having a problem with the upper part, not the basic part, while designing an elevator. If you have an example, I would like to examine how to make a design on top from normal floor level. In the appendix, I specified the place where I had a problem and added a floor plan with 1 section. I am waiting for your help. Thanks in advance.

 

[mhanifiata]

According to the project, there should be a column in the upper right corner of the elevator shaft to raise the floor level. or it is necessary to create flooring on the load-bearing wall. My preference would be to add a colon.

 

[Reform Group]

I couldn't find a solution even though I added a colon. When you play with the column lengths, it says slab edge beam overlap. it says incorrect floor level when it decreases the floor level without touching the columns. how can i solve this problem?

 

[Reform Group]

I think getting the joists and floors down at the same time solves the problem. is this the correct solution?

 

[Reform Group]

I'm also uploading a section, if you look for the latest situation and tell me your thoughts on whether it is correct, I would be happy.

 

[mhanifiata]

It is necessary to define 2 beams, one at the lower floor level and one at the upper floor level.

 

[saridurmus]

If you check the forum you will see an example of this.

 

[Reform Group]

It is necessary to define 2 beams, one at the lower floor level and one at the upper floor level.

 

[Reform Group]

If you review the

forum, you will see an example of this

I would appreciate if you add a link

 

[mhanifiata]

Attached is a suggestion for the relevant floor.

 

[Reform Group]

attached is a suggestion for the relevant floor

it's very clear now, thank you very much (=