elevator curtain

E

erdigoksu

New Member
WHAT IS MEANED IN THE MISSING MENTIONED IN ARTICLE 4 HERE I CANNOT ENTER AS A COLUMN BECAUSE THE BEAM CAN BE HOLD ONLY 10 CM TO SAVE BUCKET WIDTH
 
Hi, The reinforcement gaps in the curtain tie regions have to meet the 25Ø condition. It is seen that the curtain heads are 50cm along the critical curtain height. Since your horizontal reinforcement diameter is Ø8, the reinforcement spacing in this region should be maximum 20cm. For this, if min 8 Ø 14 is used in the header areas, this condition is met.
 
You must log in or register to reply here.
Back
Top