EDGE-AXLE DIMENSIONS IN COLUMN APPLICATION PLAN

K

katibimin

New Member
In the column application plans, version 7 does not write the distances of the column edges to the axles as a part. In the 5 versions, this was written, why is it removed now. Or can we not make an existing adjustment in the column settings, please we will be pleased if we are enlightened, greetings, respects...
 
Column joint point may not be located at axis intersections. If the columns are placed as in the example, the distances of the column edges to the axes are automatically given as in the attached picture.
 
I did not get a satisfactory answer about the distances of the column edges to the axes. I am adding a project. I had the ibodrum column application plan drawn. I could not print the horizontal distances of the SB108 column from the vertical axis no. 5 to the vertical edges. It is not possible to place the column in any other way than the specified position. .Please review the attached project and I look forward to your satisfactory answer. Good work.
 
There is a situation in which Levent Bey is described exactly in your project (column joint point is not at axis intersection). Column misalignments are measured from the nodal points. To get the drawing you want, enter the properties of the column, set the deltaX value to 25 cm, then move the column back to where it should be (25 cm to the right-K47). I hope it was a satisfactory answer...
 
I think it's satisfactory, but I wanted to explain step by step 1) Select a column of any geometry from the column tab 2) Select the intersection of the axes you want to give the offset according to which axes in the application plan as the base point 3) Adjust your spacing in the column you entered, if the column is not the axis intersection, but something else. If you give a base point according to a place, such a problem will arise. Also, if the project is new, take a look at tdy 3.4.1.1. Min. width is 25 cm
 
You must log in or register to reply here.
Back
Top