double stirrup problem

E

emrahkoyuncu

New Member
Hello friends, I had a question. After entering the foundation beams, I always enter the minimum b option for double stirrups from the foundation parameters, but then there are still single stirrup parts in my transverse reinforcements.
 
You have 70cm, 80cm and 90cm wide foundations in your project. If you want all of them to be with one stirrup, you must enter B=91cm. No, if you want all of them to be double stirrups, for example, you must enter B=65. Apart from this, if you want to have three stirrups (for example, for 90cm foundation), you must enter a value such as 45cm. I think the problem is solved.
 
I try but it doesn't improve, some of the transverse reinforcements still show single stirrups. I don't know if it's a problem with the foundation section or something else. The strange thing is, when the drawing is taken, it shows as double stirrups.
 
"emrahkoyuncu":3qqlp98m" said:
Hello friends, I had a question, after entering the foundation beams, I always enter the minimum b option for double stirrups from the foundation parameters, but then there are still single stirrup parts in my transverse reinforcements. I wonder why, thanks for your help..[ /quote] Hello, it is a case of display that it is written as fi8/10 on some stirrups in the Reinforced Concrete dialog.
Click to expand...
 
HELLO, CAN I ASK A QUESTION? I'M DOING A CONSTRUCTION ANALYSIS WITH 50X30 BEAMS ON HOLLOW FLOORING. AFTER THE ANALYSIS, IT COMES SOLVE AS A DOUBLE STRIKE, EVEN IF I DON'T SELECT DOUBLE STRIPE ON THE BEAMS. HOW CAN I AVOID THIS? HOW CAN I EDIT IT? THANKS IN NOW
 
"Erdogan Boztaş":3lxgxlmc" said:
HELLO CAN I ASK A QUESTION? I'M DOING A CONSTRUCTION ANALYSIS WITH 50X30 BEAMS ON A FRAME FLOOR. I CANNOT COME TO ANALYSIS AFTER I CANNOT SELECT A DOUBLE STRIKE ON BEAMS. THANKS IN NOW
Click to expand...
Hello, change the "Min. B for double stirrup" value from the Reinforced Concrete/Parameters/Beam Parameters dialog.
 
You must log in or register to reply here.
Back
Top