Does Not Perform Semi-Rigid Analysis

J

jumboss

New Member
When I want to analyze the structure as semi-rigid in the file I have attached, I get a warning that the system cannot be resolved - check the geometry. I can't find anything in the coordinates after the error. I built the system from scratch twice. I couldn't find the source of the error. Can you help me?
You do not have permission to view link Log in or register now.
alternative link
You do not have permission to view link Log in or register now.
 
Hello, To fix the problem: Connect the K14 beam on all floors to the columns from the left corner and define it from the bottom. 1. 2.3. make K23 beam defined 45 cm on the floor ceiling. You can find the corrected project attached.
You do not have permission to view link Log in or register now.
The issue appears in version 7 due to not networking. There is no problem with the 8 version.
 
You must log in or register to reply here.
Back
Top