Different index number in two rigid diaphragms

L

lozhan

New Member
In a project where I made a risk analysis, two different rigid diaphragms are formed due to the stage. The program automatically assigns separate index numbers to rigid diaphragms. For example, SZ01 becomes SZ101. Or SZ19 becomes SZ219. This is how it is printed in reports. How can I convert this to a single index number?
 
If you want to give the same index number to each rigid diaphragm in systems with more than one rigid diaphragm, give the same index by separating it with commas in the Index column in the Floor General settings. Good work
 
You must log in or register to reply here.
Back
Top