Deformations are the same on all floors

Even though I reduce or increase the roof loads, there is no movement, the deformations are the same on all sides.
 
Hi There is no problem with modelling. You can see the deformations by clicking play as attached. Unver ÖZCAN
 
"servany2":um7k0v5e" said:
hello, did I make a mistake in the modeling with the same amount of deformation on all floors in the project I solved, can you help me?
Click to expand...
Hello, I think you are talking about the formation of a single color when you look at the deformations after the analysis. You can see that the deformation values are different even though it shows a single color. If you want, you can see the color change in the deformation by making the support condition of the stairs supported on the curtain fixed on the ground floor. Also, there was information on this subject in the forum. [ url=http://www.idecadsupport.com/forum/viewtopic.php?f=5&t=6883&p=29457&hilit=deformation+tek+colour#p29451]viewtopic.php?f=5&t=6883&p=29457&hilit=deformation+tek+ color#p29451[/url] Good work.
 
First of all, I would like to thank you both for your interest, yes, I was talking about seeing one color exactly as you said, I couldn't see it in the forum, thank you again, good work
 
You must log in or register to reply here.
Back
Top