Defining the Mezzanine

[stapro]

Hello there; In the project I will do, I will define a mezzanine floor on the ground floor with a floor height of 550 cm, but when I manually correct the intermediate floor in the general floor settings (as 275 cm), the floor numbers get confused when drawing. Mezzanine element numbers are printed as ground floor, ground floor element numbers are output as 1st floor, 1st floor element numbers are output as 2nd floor. Thanks

 

[abaci09]

in the floor general settings dialog; 2 1.floor 1 change its name to 1.floor make a mezzanine h=.... 0 ground floor h=... ....... you can define it.