Defining the curtain end region at the junction of two curtains

[kyuceturk]

Hello, There is a 6m ground floor in a project, and there are 30cm thick curtains in the building. The structure is about 50m high and the core curtains reach this height. When I do the geometric control of the model, I naturally get the error that the thickness of the header area is insufficient in the ground floor curtains. My question is how can I model the curtain end region arrangement at the junction of two curtains. Thank you Kutay

 

[unver]

Hello, if you add your Poroje we can give you a better idea. Unver ÖZCAN

 

[kyuceturk]

Since the file size does not fit in 4mb, I am sending it in two parts. Thanks in advance

 

[HakanŞahin]

how can I model the arrangement of the fret region at the junction of two frets.

Hello, You can change the fret region lengths for any fret in the fret settings.

 

[kyuceturk]

Hello Mr. Hakan, Thank you for your answer, but actually the subject I am trying to ask is a little different. Actually, I don't want to change the length of the curtain end region, I want to use the combined curtain as the curtain end region. This is how I would like to meet the requirement (h/15) that the curtain end regions in the specification should be thicker. I tried to illustrate it below. So I'm going to equip these shaded sections like a title. I guess we can't do this automatically with idecad. So, how can we get rid of the error that the end zone wall thickness cannot be less than 1/15 of the storey height? Thank you. In addition, it cannot perform modal analysis during the analysis phase. While examining the model, I saw that the DNs of the meshes were not connected in some wall regions. Are these a visual issue? I have attached the picture below