CURTAINS and PILE FOUNDATION

[serdar]

HELLO, AS I WATCHED THE FORUM, THE NEW VERSION IS 6.0100 ON THE ROAD, I BELIEVE WE CANNOT MAKE A GAP IN THE BODRUM CURTAINS, CREATING THE PROBLEM OF INCOMPATIBILITY WITH THE ARCHITECTURAL PROJECT. I SHOULD HAVE INCREASED IN THE NUMBER OF PAGES WHILE RECEIVING THE REPORT AT 6.0055, which caught my attention. Best Regards.. Take it easy

 

[YasinTezel]

HELLO, AS I WATCHED THE FORUM, THE NEW VERSION IS 6.0100 ON THE ROAD. WE CANNOT MAKE A SPACE IN THE BODRUM CURTAINS. I SHOULD I HAVE INCREASED IN THE NUMBER OF PAGES WHILE RECEIVING A TE REPORT.. REGARDS.. GET EASY

Hello, Serdar, In ideCAD Static 6 version, you can add any door or window you choose from the Library with the Door/Window command to the basement curtains in any size you want. You need to switch to plan mode.In the link below, examples of pile foundation studies are given.

You do not have permission to view link Log in or register now.

As the report format, versions 5 and 6 are completely different. Since reports with detailed explanations and figures are supported in 6 versions, the number of report pages there has been an increase. Good work. Good luck with.

 

[yselimcamas]

I also have a problem with the report. i don't know if it's just me when i turn it off. When you turn it on again, you get a report, all values in the column buckling calculation (moment amplification method) are "0".

 

[YasinTezel]

I also have a problem with the report. I don't know if it's just me when I analyze a project and get a report etc. when I close it. values are "0".

Hello, there is no such problem at the moment. If you send your project, I can examine it. If you are using a version older than 6.055, you should update. Good work

 

[kazimyirmibes]

HELLO, AS I HAVE WATCHED THE FORUM, THE NEW VERSION IS 6.0100 ON THE ROAD, WE CAN'T MAKE A GAP ON THE BODRUM CURTAINS, WE CANNOT MAKE A PROJECT WITHOUT RESPONSIBILITY, WE CANNOT MAKE A PROJECT WITHOUT RESPONSIBILITY OF FORMATION WITH THE VERSION, YOU SOLVE THESE. I SHOULD HAVE INCREASED IN THE NUMBER OF PAGES WHILE RECEIVING THE REPORT AT 6.0055, which caught my attention. Best Regards.. KEEP IT EASY

Hello Serdar, You can add any door or window you choose from the Library to the basement curtains in ideCAD Static 6 version with the Door/Window command in any size you want. For this, you must first switch from the formwork plan mode to the architectural plan mode. In the link below, examples of pile foundation studies are given.

You do not have permission to view link Log in or register now.

Version 5 and 6 are completely different as report format. Since reports are supported with detailed explanations and figures in 6 versions, the number of report pages has increased. Good work. It's easy.

 

[YasinTezel]

I CANNOT DO THINGS REGARDING THE CALCULATION OF SPACE AND SURFACE VOLUME IN PILE FOUNDATION SCREENS WITH THIS NEW VERSION OR I CANNOT KNOW THE COMMANDS IN THIS NEW VERSION OR I DON'T KNOW THE VARDA COMMANDS on the door in StatikpenC version 6.00 Hello Beycerei. You can open the panels and analyze them.But I think your question is about the drawing possibilities you have seen in the link below

You do not have permission to view link Log in or register now.

The new features announced on the above page include improvements to version 6.0100. These features are not available in ideCAD Static version 6.0055, which is currently in use.