Curtain Thickness Error

[recepaligeldim]

Hello, I am getting the error that the wall thickness cannot be less than 1/16 of the floor height in the geometry control section of the Attic in my project. Is curtain thickness control carried out in the attic? Also, I could not understand if TBDY does not meet the 1/20 and 250 mm conditions in the 7.6.1.3 part. Is there any other method that I will have to reduce the floor height or not? Also, in the Attic Floor, the K1506 and K1517 Beams and the GP4 curtain combination do not intersect due to the architecture, how healthy is that. I'm a fresh graduate, I've been using the program for about 2-3 months and I'm a bit of a novice. I'm open to your suggestions, how can I go about it. Thanks. Project Link:

You do not have permission to view link Log in or register now.

 

[YasinTezel]

Hello. Your attic height is 405 cm, and the curtain thickness should not be less than 1/16 of the storey height according to TBDY 7.6.1.2(a) 405/16 = 25.31 You are getting an error because the curtain thickness is 25 cm. Cross-sectional conditions must be provided for curtains, except for board curtains. The floor height can be reduced to 400 cm. You can connect the K17 Beam at a slight angle so that it is completely stuck in P22. It would be more appropriate to buy the curtains on the same axle. I recommend that you take the core curtains on the same axle and connect them with tie beams on all floors.