Column free height

[kadirbulut2012]

Hello, how do we enter column free height in a project? For example, between a 0.5 m floor slab and a 3.60 m building, there is a 2.0 m high beam connected to the column. The beam dimensions are 25/50. then do we enter the freedom of that column as 1 m? And do we only enter for the floor it is on? -1 is not bad, we are writing 1 m directly, right? I was confused because the program took the 0 level from the ceiling of that floor. I didn't know if I should write -2.10 or 1 meter. thanks in advance.

 

[HakanŞahin]

Hi, how do we enter the column free height in a project? For example, between a 0.5 m slab and a 3.60 m building, there is a 2.0 m beam connected to the column. beam dimensions 25/50 o beam's lower elevation It has a level of 1.5, and the beams of the floor below are connected at 0.5. In this case, do we enter the freedom of that column as 1 m? and do we enter only for the floor it is located? I didn't know if I should write .-2.10 or 1 meter. Thanks in advance.

Hello, Normally, you don't need to enter column free height. Upload your project, if you specify in the following column as I want to change the column free height for this reason, we can write exactly what you need to do.

 

[kadirbulut2012]

I get the error S01 "Cannot provide shear safety". When I looked at the forum, I came across the questions answered to change the column free height, similarly. That's why I wanted to ask the free height. the project is attached.

You do not have permission to view link Log in or register now.

(the elevation of the column/ground floor to which the beams in the middle circular region are connected - Beams are connected to 4 columns in 1.5-meter parts)

 

[HakanŞahin]

Hello, In your project, column free height cannot be found on columns SZ18, SZ20, SZ129, SZ131. Give the free heights of these columns 1.5 meters as the remaining distance between the curtain and the beams. You can leave it as "find the program" in other columns. Good work