Column beam joint design

[ozgunerdogan41]

Take it easy, I want to make a combination as I have marked in a system consisting of I profiles, as in the draft I shared in the appendix. Is it possible to create this design with idecad?

SM -Sent from my N950F using Tapatalk

 

[nurgulkaya]

Hello there; If there is a cross-sectional difference where there is a support joint, reinforcement and fracture, you can obtain the geometry by using the butt plate joint joint. Good work.

 

[ozgunerdogan41]

Thank you for your reply. Do you have a chance to share an example? Sent from my SM-N950F on the model using Tapatalk

 

[nurgulkaya]

As an example, the attached project can be shown. If there is a geometry other than this, please send the model and we will try to help you with your model. Good work.

 

[ozgunerdogan41]

Thanks for the answer, how can I make a triangle cut on the beam on this support Sent from my SM-N950F using Tapatalk

 

[nurgulkaya]

Hello there; If you are asking about making the beam as seen in the drawing above, such a process cannot be done in the interface. After receiving the drawings, you can only intervene through the drawings.

 

[2m proje]

Hello there; As a suggestion, you can also create the support area detail in the image as a solid model in the program, even if it is a little troublesome, as I have shared the attached data file. 1- Create the plate sections needed in the joint as defined sections. 2- Draw the defined sections as a single purlin (in order not to include them in the analysis model because we use them as purlins) at the required length and elevation. 3- Weld the profile properly with the plates you created. Best regards.

 

[ozgunerdogan41]

This is what I was looking for Thank you very much Sent from my SM-N950F using Tapatalk

 

[nurgulkaya]

Hello there; I recommend using this model as a drawing model, not as an analysis and design model.