Colon Appl. plan

Y

yakubu

New Member
Hello friends; When getting the column appl.plan, for example; We use the open details option. In square columns, the number of reinforcements on the major and minor sides is different or I want to do it differently on purpose. However, when we look at the detailed drawings, it is not clear in which direction we will apply the square column. Especially at the construction site, the craftsmen do not know which reinforcement number will be placed on which side of the column. In this drawing option, is it possible to put at least a mark indicating the placement direction of the square column on the detail drawings? for example; Can the axis name and direction of the relevant square column be specified? Good work everyone...
 
Re: COLUMN APL. PLAN Hello, your blacksmith will draw the pegged axles on the wire in the application. Even though it is in the column, you have axes that determine the direction in the end. Frankly, I did not understand the part that they failed in practice
 
Re: COLUMN APL. PLAN Mr. Ömer; First of all, thank you for your interest. What I want to say is this. colon from the program apl. When we use the open details outside option, we do not see the column reinforcement details on the plan. As seen in the picture, there is no direction mark on how the column will be placed on the detail drawing. If it is a rectangular column, you can see how the short side and long side are placed in the plan, but in the square column, for example, 6 pieces of reinforcement calculated in the x direction, I could accidentally put in the y direction. I mean this. We can describe this to the master at the construction site, but I am saying that in projects with many square columns, at least in the drawings, it may be easier. otherwise there is no problem. It's all about the vertical reinforcement of the square column, not the column application or axis placement. thank you. good work.
 
Re: COLUMN APL. PLAN
"yakubu":210v4lcs" said:
The number of reinforcements on the major and minor sides is different in square columns or I want to make them differently on purpose. However, when we look at the detail drawings, it is not clear which direction to apply the square column. They obviously do not know which number of reinforcements to put in. Is it possible to put at least an indication of the placement direction of the square column on the detail drawings in this drawing option?
Click to expand...
Your request has been taken into our notes. Good work.
 
You must log in or register to reply here.
Back
Top