Cassette floor ribs

[yunussacikk]

Hello. How are we going to understand the direction (x or y direction) of our ribs in the cassette slab on the printouts?

 

[HakanŞahin]

Hello, In the cassette reports, there is no information in the x and y directions for the cassette teeth. However, the 1st selected typical tooth appears as 1, and the 2nd selected type tooth appears as 2. When specifying typical teeth, if you define all teeth in the x direction as 1st, all 1st teeth will appear in the x direction. You can also understand by the thread openings in non-square systems.

 

[yunussacikk]

Would you consider adding an index so that they can understand the orientation of these teeth on site?