CASSETTE DRAWS THE FLOOR BEAM IN ONE WAY ONLY

btemel52

New Member
Dear ide construction technical service: In the cassette slab project, which I sent by compressing, when taking the cassette slab beam drawings, the selected cassette slab draws only one horizontal (xx) cassette beam in one direction, whereas if you look at the project, I have chosen a typical beam in both directions. Only one beam as NZ01a 15/45. drew look: cassette drawing sheet However, in version 5, typical beams were drawn in 2 directions. I wonder if I made a mistake somewhere. I am sending the project in the attachment, please, if you are interested and inform me, I would appreciate it. Also, I present it to the attention of your friends in the forum, thank you, good work
 
Dear Btemel52, After the slab analysis is done in the cde extension project you sent, drawings of beams in both directions can be taken in all cassette slabs, including the slab you specified.
 
Thank you, Mr. Levent, I realized later that the typical beams should be in the same direction in the selected drawings, good work
 
Back
Top