Cannot resolve system on modal load

S

sadikcafer

New Member
Hello. My project is attached, I get a warning that the system cannot be resolved from the modal installation. I did a detailed search but couldn't find it. I would be glad if you could help. In the project, the level difference on the basement ceiling has arisen because one side is a shop and one side is a flat. Since the architecture was not completely finished, I made a study for pre-sizing, the attic and engine rooms were not fully adjusted. good work.
 
It's probably because you shortened the column lengths in the basement and didn't lengthen the ones on the ground floor. There are also overlapping floors on the 1st and 2nd floors. I'll fix them too. I haven't been able to try it in detail.
 
"NYILMAZ":10lq714u" said:
It's probably because you shortened the column lengths in the basement and didn't extend the ones on the ground floor. There are also floors on the 1st and 2nd floors. I'll fix them as well. I looked, there seems to be no overlap. Can you write the names of which numbered tiles? Also, I did not make any changes in the column sizes, it is because you did not extend them.
Click to expand...
 
Slabs, eg 2nd floor D20, D25. Floors in the same place on a lower floor. What I said about the column sizes; curtain length in the basement (upper level) -50 . At the same point, if the column upper levels are -50 and the lower ends of the column on the ground floor are -50, the beams junction point will become a nodal point.
 
"sadikcafer":3plr79fa" said:
Hello My project is attached, I get a warning that the system cannot be solved from modal installation. I did a detailed investigation but could not find it. I would appreciate it if you could help me. I did a work for pre-sizing for the attic. Good work.
Click to expand...
Hello, The system cannot be resolved warning is due to the combination of P10-P18 in the basement. Also, model the panel objects as shells on all floors. Examine the errors in the geometry control. Good work
 
GREETINGS..I HAVE PROBLEMS IN THE MODAL ANALYSIS SECTION, I HAVE A PROJECT WITH BODRUM+GROUND+GALLERY +9 FLOOR AND WHEN I ADD FLOOR AFTER 7 FLOORS, IT DOESN'T ANALYZE, HE WANTS GEOMETRIC CONTROL, GEOMETRIC CONTROLLERS.
 
You are unlikely to find a solution for such a problem without submitting a project. We can only understand where there is a mistake by looking at the project.
 
You must log in or register to reply here.
Back
Top