Cannot change dimension

[katibimin]

In the project that I sent in abbreviated form, after I received the mold plan, I cannot round the dimensions that I have marked and which are fractional after the comma. Whichever setting I have changed to the dimensioning settings without taking the mold plan, I can't measure the dimensions, for example: How can I make the dimensions 131.5 131 cm or the one above, and the 98.5 98 or 99? it's done by blowing up the dimensioning in the dimension, but it takes quite a while to change that many dimensions. Thanks in advance for your interest.

 

[cakilomer]

Re: MEASUREMENT CANNOT BE CHANGED Hello, as far as I know, the program rounds .5 below and above in axis dimensioning, but when it is .5, it gives that measurement directly. good work

 

[Levent Özpak]

In the project I sent abbreviated in the appendix, I cannot round the fractional measurements I marked after the comma, after I received the mold plan. Whichever setting I changed to the dimensioning settings without taking the mold plan, the dimensions were for example: 131.5 131cm or a On top of that, it is possible by blowing up the dimensioning like how can I make a 98.5 one to 98 or 99, but it takes a lot of time to change so many dimensions. Thank you in advance for your interest.

Hello, In the mold plan, the dimensioning unit and the number of digits are automatically determined by the program. If desired After the mold plan is received, it can be resized according to the desired display shape with the Free dimensioning command.